[amsat-bb] SatPC32- Auto Sat Change?
PE0SAT | Amateur Radio
pe0sat at vgnet.nl
Wed Jun 15 13:28:14 UTC 2016
Check and double check the prior.sqf. I use it with success but have
run into problems where
for example there is a dash number in the Satellite name and the
So first start with just a couple and not more then nine.
Maybe share you prior.sqf file to see if there is an error in it.
73 Jan PE0SAT
On 15-06-2016 08:33, Allen Burrell wrote:
> I have successfully implemented control of my Yaesu G-450/G-550
> rotors via ERC using SatPC32. I can now track satellites across the
> sky as I await arrival of transverters to work with my Flex-3000/1500
> combo. I have not been able to get the Auto Sat Change feature to
> work, however. I have set up prior.SQF with a list of prioritized
> satellites, and set Auto Sat Change to “A+”. When a satellite becomes
> available, the lettered box highlights, but no changing of satellite
> to the active one occurs on the screen. Only after I click on the
> highlighted letter box does it activate the available satellite,
> allowing rotor control, and later, I hope, frequency tracking. What am
> I overlooking? Thanks for any help. Al, KI7RM
> Sent via AMSAT-BB at amsat.org. AMSAT-NA makes this open forum available
> to all interested persons worldwide without requiring membership.
> Opinions expressed
> are solely those of the author, and do not reflect the official views
> of AMSAT-NA.
> Not an AMSAT-NA member? Join now to support the amateur satellite
> Subscription settings: http://www.amsat.org/mailman/listinfo/amsat-bb
With regards PE0SAT
Internet web-page http://www.pe0sat.vgnet.nl/
DK3WN SatBlog http://www.dk3wn.info/p/
More information about the AMSAT-BB