[amsat-bb] Re: Satpc32 Storing Rx/Tx addreses

Erich Eichmann erich.eichmann at t-online.de
Mon Sep 30 00:54:22 PDT 2013

Hello Carl,
set the Icom addresses in the menu "Radio Setup". Click on the little 
control right hand of the word "Model". In the list that opens choose 
"Addresses". The first Icom address pair will be displayed in the address 
window. With the up/down controls set the address values. If you use a 
single Icom transceiver both addresse values must be equal. If you use 
separate Icom radios for RX and TX set the first address value for the RX, 
the second one for the TX.   Then click "Addresses OK"  and  then the Store" 
button. If you use a single  Icom radio as TX (besides another brand as RX) 
set the address value in the "Radio 2" section of the menu.

If you want to change the multiple address pairs that appear in menu "Mode" 
choose "Addresses" in menu "Radio Setup" as described above. Click on the 
little control right hand of the address window. Choose and modifiy the 
other address pairs and save the changes of each pair.

73s, Erich, DK1TB

----- Original Message ----- 
From: "carl creamer" <ccreame at pacbell.net>
To: <AMSAT-BB at amsat.org>
Sent: Sunday, September 29, 2013 9:10 PM
Subject: [amsat-bb] Satpc32 Storing Rx/Tx addreses

I'm having an issue with having Satpc32 storing the Mode/Rx/Tx addresses.
When I start the program, I store the correct settings for my Icom and it 
all works fine , but when I reboot and/or restart the Satpc32 later I have 
to go to the mode screen and reset the Mode/Rx/Tx addresses.
Is this normal or is there a way to have them permanently stored?
Sent via AMSAT-BB at amsat.org. Opinions expressed are those of the author.
Not an AMSAT-NA member? Join now to support the amateur satellite program!
Subscription settings: http://amsat.org/mailman/listinfo/amsat-bb

More information about the AMSAT-BB mailing list