[Date Prev][Date Next][Thread Prev][Thread Next] - [Date Index][Thread Index][Author Index]

Re: ISS & SATPC32 and IC-910

For 2 meter up- and downlink (the normal mode for ISS), you must use the 
special ISS version of SatPC32, SatPC32ISS, which puts the transceiver in 
"split" mode, rather than satellite mode.  You must also provide a 
handshaking signal to your serial port to prevent the software from trying 
to change frequencies while transmitting.

See the file SatPCISS.txt in the program folder for details.

Good luck!!

George, KA3HSW

----- Original Message ----- 
From: "Mike McConnell" <w0pd@mchsi.com>
To: <amsat-bb@amsat.org>
Sent: Friday, October 17, 2008 9:35 PM
Subject: [amsat-bb] ISS & SATPC32 and IC-910

> Is SATPC32 supposed to switch the IC-910 to the correct VHF TX/RX
> frequencies (as it does for sats) in mode U/V?  If so, how do you do it. I
> was just playing with the radio and software and it seems to command the 
> RX
> frequency but the TX frequency isn't correct. I was thinking about trying 
> to
> talk to the ISS sometime.>Thanks
> Mike McConnell, Ph.D.
> W0PD

Sent via AMSAT-BB@amsat.org. Opinions expressed are those of the author.
Not an AMSAT-NA member? Join now to support the amateur satellite program!
Subscription settings: http://amsat.org/mailman/listinfo/amsat-bb