[Date Prev][Date Next][Thread Prev][Thread Next] - [Date Index][Thread Index][Author Index]

Re: Kenpro elevation rotor repair



Hello Sebastian,

I would send it to Larry, K6VLF. Larry has parts for these rotors and gets them out very fast and does a great job in overhauling them..

73,

Dave / W6TE
  ----- Original Message ----- 
  From: Sebastian<mailto:w4as@bellsouth.net> 
  To: AMSAT BB<mailto:AMSAT-BB@amsat.org> 
  Sent: Saturday, September 27, 2008 8:01 AM
  Subject: [amsat-bb] Kenpro elevation rotor repair


  Well I had been back on the birds for the last 3 months or so, and  
  while I was getting ready for an AO-16 pass a few days ago, my  
  elevation rotor on my Yaesu G-5400B stopped at about 10 degrees.

  That's it.  It won't go back down or up.

  So I checked the wiring on the rotor, everything appeared fine.  I  
  removed the elevation rotor from the azimuthal, and took it inside.  I  
  made a small patch cord to go from the control box to the rotor, but  
  no luck.  All I get is the display of the elevation of about 10  
  degrees, and I hear a little hum when I attempt to move it up or  
  down.  This tells me that the potentiometer is probably good, and the  
  motor is receiving power.

  I've removed the small nameplate on the side, and there is no water  
  inside, and I can see the ball bears; there doesn't appear to be any  
  rust inside.  I also removed the terminal assembly in case one of the  
  wire had come loose, or had a cold solder joint, but I didn't find any  
  problems there.  Looking at the diagram of the rotor, there appears to  
  only be a small 24 volt motor which turns this; along with numerous  
  mechanical parts.

  So the question is.  Before I send this to Yaesu, has anyone had this  
  problem before, is it a minor one (something that I could fix myself),  
  or is best left to Yaesu?  Before anyone mentions, Norm's no longer  
  services these rotors.  The four 'screws' that hold the two parts are  
  impossible for me to loosen.  I would have to use a vice, but I do  
  have a friend with a motorcycle repair business who I'm sure could  
  open it for me in 60 seconds.  To me, this looks like a jigsaw puzzle  
  by looking at the diagram.

  The rotor was in service for about a couple of years back in the early  
  90s.  It then sat inside without any use, up until a few months ago.   
  If the consensus is to send it to Yaesu, should I bother to send in  
  the azimuthal rotor, or should I follow the "don't fix it if it aint  
  broken" rule?

_______________________________________________
Sent via AMSAT-BB@amsat.org. Opinions expressed are those of the author.
Not an AMSAT-NA member? Join now to support the amateur satellite program!
Subscription settings: http://amsat.org/mailman/listinfo/amsat-bb



AMSAT Top AMSAT Home