[Date Prev][Date Next][Thread Prev][Thread Next] - [Date Index][Thread Index][Author Index]

Re: brain picking time



Ed and all
Many thanks for the information from many of you.  I realize I will need a preamp.  For now I will be content to see what I can hear.  As you can guess once I can copy signals I will want to join in.  That will require at very least mounting the amp at the antenna and a sequencer.  I have seen W0LMD' web site as well as several others.  I want to start out slow, before I "lose it".
73 Bob W7LRD


--
"if this were easy, everyone would be doing it"

-------------- Original message -------------- 
From: Edward Cole <kl7uw@acsalaska.net> 

> Domenico, 
> 
> You said it well. I forgot to mention that polarity sense will 
> reverse upon reflection at the dish surface, so the feed sense should 
> be Rx=RHCP; Tx=LHCP. In other discussions about using a patch for 
> eme, concern has been about sidelobe performance and high power 
> rating of the patch if full QRO eme is considered. Up to 200w it 
> probably is OK. 
> 
> I assumed that Bob was savy enough about microwave weak-signals to 
> know that on eme a preamp is not a luxury but an absolute 
> necessity. LMR-400 would be fine for connection from the preamp to 
> the receiver in the shack, if at least 15-dB net gain is left after 
> the cable loss is subtracted. More gain is desirable if the receiver 
> NF is high. A preamp of 0.3 dBNF is standard at 1296 for eme. 
> 
> I have a WD5AGO two-stage preamp with 0.30dBNF and 31-dBgain bought 
> from Radio Astronomy Supply. 
> 
> 73 Ed - KL7UW 
> 
> At 05:54 PM 8/5/2008, i8cvs wrote: 
> >----- Original Message ----- 
> >From: "Edward Cole" 
> >To: ; "AMSAT-BB" 
> >Sent: Tuesday, August 05, 2008 8:24 AM 
> >Subject: [amsat-bb] Re: brain picking time 
> > 
> >At 04:35 PM 8/4/2008, w7lrd@comcast.net wrote: 
> > 
> > >Next question- which probably would be more aimed at a EME bb. I 
> > >have a 12 foot TVRO I am building a patch feed for 1296, and feed it 
> > >through 50 feet of LMR400 to my IC-1271A. I want to see if I am 
> > >able to "hear" EME signals. Of course if I am able to, you can 
> > >guess what my next effort will be. This will be a cheapie effort as 
> > >I am only using stuff I already have. I do have a KJ6KO L band 70 watt 
> >amp. 
> > >73 Bob W7LRD 
> > >Seattle 
> > 
> > > Bob, 
> > > 
> > > Is your patch feed circular polar? EME on 1296 is RHCP in transmit 
> > > and LHCP in receive. 
> > 
> >Hi Ed, KL7UW 
> > 
> >It is best to specify to Bob that on 1296 MHz the dish in transmit must 
> >radiate RHCP in direction of the moon so that the patch or any other 
> >feed must radiate LCHP in direction of the surface of the dish. 
> > 
> > > The switch of polarity sense is due to the fact 
> > > that reflection at the moon reverses the sense of polarization. 
> > 
> >OK 
> >So that on receiving the wave coming from the moon is received LHCP 
> >over the surface of the dish but the dish reverse by reflection the signal 
> >in direction of the feed that must be made RHCP polarized on receiving. 
> > 
> >In addition a TVRO dish works well with a patch feed if the F/D ratio of 
> >the dish is ranging from 0.35 to 0.45 
> > 
> > > might be difficult to achieve with a patch feed. 
> > 
> >W0LMD make a patch feed for RHCP and LHCP but never I tested it 
> > 
> >Since the target of Bob is to see if he is able to only "hear" EME signals 
> >at 1296 MHz without to complicate his life I suggest at the very beginning 
> >to build only a patch feed RHCP polarized. 
> > 
> >To receive a 1296 EME signal with a 12 foot TVRO and a IC-1271A 
> >it is strictly necessary to connect directly to the patch connector a low 
> >noise preamplifier with a NF in the order of 0.5 dB 
> > 
> >Since the gain of a low noise EME preamplifier for 1296 MHz is 
> >in the order of 30 dB or more then 50 feet of LMR400 connected from 
> >the output of the preamplifier up to the input of the IC-1271A will not 
> >deteriorate the overall NF of the system that will be only a little bit 
> >higher than 0.5 dB 
> > 
> > > 73 Ed - KL7UW 
> > 
> >73" de 
> > 
> >i8CVS Domenico 
> 
_______________________________________________
Sent via AMSAT-BB@amsat.org. Opinions expressed are those of the author.
Not an AMSAT-NA member? Join now to support the amateur satellite program!
Subscription settings: http://amsat.org/mailman/listinfo/amsat-bb



AMSAT Top AMSAT Home