[Date Prev][Date Next][Thread Prev][Thread Next] - [Date Index][Thread Index][Author Index]

Re: Antenna near gas lines?




Hi Rick,

The only other thing I would add is to be sure that the RF doesn't find its way to the furnace's controller or thermostat.  I have a dipole strung across the ridge of our roof (end-to-end, about a foot above it), with the upstairs furnace in the attic below.  Depending on its mood (the only explanation I can think of), I sometimes hear strange and loud noises from up there when I work 40 meters.  It doesn't happen all the time, but it can't be good when it does.

Greg  KO6TH.


----------------------------------------
> From: domenico.i8cvs@tin.it
> To: rmann@latencyzero.com; amsat-bb@amsat.org
> Date: Tue, 22 Jul 2008 05:08:08 +0200
> Subject: [amsat-bb] Re: Antenna near gas lines?
> 
> ----- Original Message ----- 
> From: "Rick Mann" 
> To: "amsat Org" 
> Sent: Tuesday, July 22, 2008 3:42 AM
> Subject: [amsat-bb] Antenna near gas lines?
> 
> 
>> Hi. Sorry for the somewhat off-topic post.
>> 
>> I recently moved into a townhouse with a lovely homeowner's  
>> association. Rather than fight them putting up my antenna outside, I  
>> decided to just mount it inside my attic. I found a spot about 3 feet  
>> away from a vertical run of the gas line to the heater (also in the  
>> attic). My first choice as a location right next to it, 'till I  
>> realized it was there.
>> 
>> Should I be concerned about creating an explosion hazard? My  
>> transmitter outputs a maximum of 100 W, and it's going into a Diamond  
>> X-30 antenna (http://www.diamond-ant.jp/ama2/eng_ama_2_2_3.asp).
>> 
>> I wouldn't think it should be a problem, since it's metal pipe, and an  
>> RF energy is unlikely to go through the gas. But sadly, I don't  
>> remember what I learned when I took my test, if it even addressed this  
>> issue.
>> 
>> Any advice would be welcome.
>> 
>> Thanks!
>> 
>> -- 
>> Rick
> 
> Hi Rick
> 
> Normally the metal pipes for gas are interrupted by insulating joints 
> to prevent electrolitic corrosion and the RF currents induced over it
> by your antenna are flowing over the outside metal surface because
> of the skin effect and they cannot penetrate inside were the gas flow.
> 
> 73" de
> 
> i8CVS Domenico
> 
> 
> 
> 
> _______________________________________________
> Sent via AMSAT-BB@amsat.org. Opinions expressed are those of the author.
> Not an AMSAT-NA member? Join now to support the amateur satellite program!
> Subscription settings: http://amsat.org/mailman/listinfo/amsat-bb

_________________________________________________________________
Time for vacation? WIN what you need- enter now!
http://www.gowindowslive.com/summergiveaway/?ocid=tag_jlyhm
_______________________________________________
Sent via AMSAT-BB@amsat.org. Opinions expressed are those of the author.
Not an AMSAT-NA member? Join now to support the amateur satellite program!
Subscription settings: http://amsat.org/mailman/listinfo/amsat-bb



AMSAT Top AMSAT Home