[Date Prev][Date Next][Thread Prev][Thread Next] - [Date Index][Thread Index][Author Index]

Re: Best type of coax to use ... in ... AMSAT-BB Digest,Vol 3, Issue 326



Someone mentioned the 2-piece type N connector for 9913 type coax.  Does 
anyone have the trimming dimensions for those?  I had to make up my own and 
wonder how good they are.
73, Harvey
K5HV

----- Original Message ----- 
From: "joe cassano aka jmario" <jmario@fast.net>
To: <amsat-bb@AMSAT.Org>
Sent: Tuesday, July 01, 2008 12:38 PM
Subject: [amsat-bb] Re: Best type of coax to use ... in ... AMSAT-BB Digest, 
Vol 3, Issue 326


Installing a classic clamp type N connector like the Amphenol 82-202
(UG-21D/U) on flexible coax with a real copper center conductor
(RG-8,RG-213) is both easier and has a much higher probability of
success than installing the common PL-259.  You only have to make one
easily accessible solder connection.

Take a look at
http://www.amphenolrf.com/products/assemblyInstructions/280.pdf to see
what is involved in attaching classic clamp style N connector.

You also might want to read the reviews listed here:
http://www.eham.net/reviews/products/7 before you make any purchase
decisions.


Regards,
JoeC - K3FMA

> ------------------------------
>
> Message: 12
> Date: Mon, 30 Jun 2008 19:49:00 -0500
> From: Ronald Nutter <rnutter@networkref.com>
> Subject: [amsat-bb]  Best type of coax to use between preamps and
> antennas
> To: amsat-bb@amsat.org
> Message-ID: <48697EFC.5010100@networkref.com>
> Content-Type: text/plain; charset=ISO-8859-1; format=flowed
>
> After problems I had on Field Day in trying to operate the satellites, I
> am looking to upgrade the coax I use between the preamps and the
> antennas.  I am using 9913FX from the IC-910H and the preamps.  I had
> been using RG Mini 8/U for the connection between the preamps and
> antennas.  Should I also use 9913FX between the preamps and the
> antennas?  The run between the radio and the preamp is 50 ft.  The run
> from the preamp to the antennas is about 10 - 15 ft depending on where I
> set the antennas up.  I am concerned about how flexible the 9913FX would
> be in terms of the antennas rotating back and forth.  I was planning on
> ordering the cables pre-made from CableXperts since working with N
> connectors isnt my strong point and dont want to worry about my
> soldering and having a good connection on both ends of the cable.
>
> Any suggestions appreciated.
>
> Thanks,
> Ron
> KA4KYI
>
>
_______________________________________________
Sent via AMSAT-BB@amsat.org. Opinions expressed are those of the author.
Not an AMSAT-NA member? Join now to support the amateur satellite program!
Subscription settings: http://amsat.org/mailman/listinfo/amsat-bb 

_______________________________________________
Sent via AMSAT-BB@amsat.org. Opinions expressed are those of the author.
Not an AMSAT-NA member? Join now to support the amateur satellite program!
Subscription settings: http://amsat.org/mailman/listinfo/amsat-bb



AMSAT Top AMSAT Home