[Date Prev][Date Next][Thread Prev][Thread Next] - [Date Index][Thread Index][Author Index]

Working the sats with FT-530 HT



Hi,

Would like to use my 530 to work the sats and have encountered a couple of problems.

* First tried full duplex with the left hand VFO set to uplink frequency and the right hand VFO set to downlink.  To transmit, the left side must be active.  But it's necessary to change the downlink frequency to account for doppler, and I can't figure out how to do this except by pressing ALT, changing the frequency, then pressing ALT again.  Is there a better way?  Some HTs have a button that allows tuning on the sub VFO, but if the 530 has it I  have not yet found it.

* Next tried half duplex by setting a memory on the left VFO with the 2 meter uplink and the 70cm downlink.  Problem is that the left VFO can't be set to tune in 5 khz steps on 70 cm (it can be set to 5 khz on 2m), and 5 khz tuning is needed for the sats.  Is there any way to tune 70cm in 5 khz steps on the left VFO?  The right hand VFO can be set to tune in 5 khz steps on 70 cm, but it will not transmit on 2m, so only the left VFO can be used for this purpose.

I have heard the 530 is a great satellite HT but it will not be satisfactory unless I can resolve the tuning problem somehow.

Thanks for any advice and 73,
Bill NZ5N


      
_______________________________________________
Sent via AMSAT-BB@amsat.org. Opinions expressed are those of the author.
Not an AMSAT-NA member? Join now to support the amateur satellite program!
Subscription settings: http://amsat.org/mailman/listinfo/amsat-bb



AMSAT Top AMSAT Home