[Date Prev][Date Next][Thread Prev][Thread Next] - [Date Index][Thread Index][Author Index]

Re: 145 MHz IF on V/s?



----- Original Message -----
From: "K & R Yoksh" <yokshs@sbcglobal.net>
To: "Amsat BB" <amsat-bb@amsat.org>
Sent: Monday, May 19, 2008 12:56 AM
Subject: [amsat-bb] 145 MHz IF on V/s?
>
> Hi all,
>
> Thanks for the replies, however, I've still not had my question answered,
> so I'll ask again.
>
> I'd like to hear from anyone using a 145 MHz IF when working mode V/s. Do
> you experience desense when operating V/s, but not other uplink modes?
>
> I'm planning to use my AIDC 3731 with 145 MHz IF when I install my dish
> this summer. I really want to use it for HEO operation, but it'd be a
> bonus if I could also work the LEOs.
>
> I could go with a 123 MHz IF unit if that'd work better.
>
> Thanks and 73,
>
> Kyle Yoksh
> K0KN
> Olathe, Kansas
>
Hi Kyle, K0KN

Don't warry about to use 145 MHz IF for HEO operation because P3-E
will use the V band only for downlink.
The builders of P3-E are aware of the problem and they don't want to
complicate the life to the users.

For the LEOs S band using downconverters 2400-2402 MHz with an IF
144-146 MHz :
Receiving AO-51 at 2401.200 MHz the IF fall into 145.200 MHz and
transmitting at 145.920 MHz FM the difference between the IF and TX
frequency is 720 kHz
In this condition there are three possible outcomes:
The 145.200 MHz uplink signal is picked up directly by the cable after
the mixer of the S band converter and sent down to the shak into your IF
receiver flowing in general through the outside surface of the braid of
the coax cable. (common currents)
The 145.200 MHz uplink signal can pass directly through the converter
first stage up to the IF receiver in the shak.
The 145.200 MHz uplink signal is picked up directly by your IF receiver
because your power is very high and TX/RX are very close.
Since there are many variables involved mostly depending on your TX power
it is very difficult to say yes or not and so a test to see if you will
suffer or not a desensing  is mandatory.
If  you have a desensing there are many possible cures for it but if you
don't have the time to work on this problem it is best to use your 123 MHz
IF unit.
I remember that receiving AO40 I got interference over the 2401.323 MHz
bpsk beacon when an amateur friend living few miles away of me was locally
transmitting FM using high power at 145.325 MHz
145.325 MHz was at the same time his own frequency and my IF frequency.
My investigation demonstrated that the interfering signal was piched up
directly by the coax cable running from the S band downconverter to the
IF receiver in the shak.
Unfortunately i don't had on hand a S band downconverter with a 123 MHz IF

Best 73" de

i8CVS Domenico




_______________________________________________
Sent via AMSAT-BB@amsat.org. Opinions expressed are those of the author.
Not an AMSAT-NA member? Join now to support the amateur satellite program!
Subscription settings: http://amsat.org/mailman/listinfo/amsat-bb



AMSAT Top AMSAT Home