[Date Prev][Date Next][Thread Prev][Thread Next] - [Date Index][Thread Index][Author Index]

Re: need plans for 70 cm preamp



 
In a message dated 26/02/2008 03:39:11 GMT Standard Time, rlasso@zianet.com  
writes:

Need  recommendations for plans for an easily constructed homebrew 70cm 
mast  mount preamp with built in RF sense TR switch (VOX controlled). I 
will not  be running more than 50 watts in New Mexico or possibly 100 
watts in CA  when I move there.
thanks and 73, Robert W6RQR



That's really tough Robert.  Unless there is some sequencing going on  inside 
your radio then any RF sensing circuit will mean that the relay contacts  
will be hot switched on transmit.
A couple of seriesed limiting PIN diodes may help, but with 100W across  them 
for a few 10s of milliseconds even that may not be enough to protect the  
Pre-amp.
 
On the preamp side, the design that was published in the journal in August  
(2006?)  works well and has a noise figure of 0.5dB and is a no tune  design.  
Details are on  g0mrf.freeserve.co.uk
 
Thanks
 
David



   
_______________________________________________
Sent via AMSAT-BB@amsat.org. Opinions expressed are those of the author.
Not an AMSAT-NA member? Join now to support the amateur satellite program!
Subscription settings: http://amsat.org/mailman/listinfo/amsat-bb



AMSAT Top AMSAT Home