[Date Prev][Date Next][Thread Prev][Thread Next] - [Date Index][Thread Index][Author Index]

Re: Cable question



Either run LMR-400 all the way (70-foot) or for lower loss run 
50-foot 1/2-inch hardline (Andrew Heliax LDF4-50A) + 20-foot of 
LMR-400.  Use N-female connectors on the hardline and N-male on the LMR-400.

The telescoping mast is not very rigid for a rotor and antennas so 
you need guy lines at 10 & 20 foot levels.  Raising and lowering will 
be tricky so you should have 2-3 people to help you.  Why not look 
for two sections of Rohn-25 tower (used can be had for $50/section)?

Ed - KL7UW

At 08:31 AM 1/8/2008, Ollie Eisman wrote:
>Hi everyone,
>
>I would like to use a G-5500 rotor on top of a 20' telescopic mast with
>2m and 70cm sat antennas.  Assuming this isn't a bad idea to begin with,
>my next goal is to find RF cables that will work best with this type of
>tower given it will be raised and lowered frequently, thus causing a lot
>of extra cable flex.  (I am not even sure of the best way to run cables
>up the to rotors when the mast is telescopic - ideas?)
>
>I am looking at 20+' for the tower plus another 50' or so back to the
>shack.  An suggestions?
>
>Love those covenants... :)
>
>73,
>Ollie, AJ1O
>_______________________________________________
>Sent via AMSAT-BB@amsat.org. Opinions expressed are those of the author.
>Not an AMSAT-NA member? Join now to support the amateur satellite program!
>Subscription settings: http://amsat.org/mailman/listinfo/amsat-bb

73,
Ed - KL7UW
======================================
  BP40IQ   50-MHz - 10-GHz   www.kl7uw.com
144-EME: FT-847, mgf-1801, 4x-xpol-20, 185w
DUBUS Magazine USA Rep dubususa@hotmail.com
====================================== 

_______________________________________________
Sent via AMSAT-BB@amsat.org. Opinions expressed are those of the author.
Not an AMSAT-NA member? Join now to support the amateur satellite program!
Subscription settings: http://amsat.org/mailman/listinfo/amsat-bb



AMSAT Top AMSAT Home