[Date Prev][Date Next][Thread Prev][Thread Next] - [Date Index][Thread Index][Author Index]

Re: Duplexer Terminator



Hi Al,

Have you looked at http://www.amsat.org/amsat-new/articles/Mode-J/ ? If you 
install it the way the diagram indicates, you won't need the 50 Ohm load. 
This setup kills the desense cold. If you really insist on the terminator, 
solder a 2 watt 50 Ohm resistor across a connector...but trust me you don't 
need it as long as it is set up like in the article.

73, Drew KO4MA

----- Original Message ----- 
From: "Al Ozias" <alozias@worldnet.att.net>
To: "AMSAT" <amsat-bb@amsat.org>
Sent: Monday, February 26, 2007 4:28 PM
Subject: [amsat-bb] Duplexer Terminator


>I am looking for a source of a 50 ohm SO-239 Terminator for use on the 2m
> side of a Duplexer.  Any comments on the use of a Duplexer for sensing
> problems wold also be appreciated, I am presently (successfully) using a 
> DCI
> filter in the shack following the pre-amp but wonder if a duplexer after 
> the
> pre-amp near the antenna might be a better solution.  I would like to
> increase the size of my ears.
>
> Thank you Al - N7EQF
>
>
> _______________________________________________
> Sent via AMSAT-BB@amsat.org. Opinions expressed are those of the author.
> Not an AMSAT-NA member? Join now to support the amateur satellite program!
> Subscription settings: http://amsat.org/mailman/listinfo/amsat-bb
> 


_______________________________________________
Sent via AMSAT-BB@amsat.org. Opinions expressed are those of the author.
Not an AMSAT-NA member? Join now to support the amateur satellite program!
Subscription settings: http://amsat.org/mailman/listinfo/amsat-bb



AMSAT Top AMSAT Home