[Date Prev][Date Next][Thread Prev][Thread Next] - [Date Index][Thread Index][Author Index]

Re: 9600 baud with IC-910H



Hi Ryan,
   page 13 of your manual sums it up, pin 4 on the mini din is where you 
want
to be, and yes the 910 will not tolerate overdriving on 9600, it will  cut 
off
transmit if you do...

73
Kevin WA6FWF
Amsat-UK #6505

----- Original Message ----- 
From: "Ryan Butler" <rbutler@tsss.org>
To: <amsat-bb@AMSAT.ORG>
Sent: Tuesday, December 27, 2005 7:30 PM
Subject: [amsat-bb] 9600 baud with IC-910H


> Hello,
>
> I had a PK-900 married up to my IC-821H (which I have since sold), 9600
> worked great.  I bought a IC-910H and am getting around to hooking it
> up, which I figured would be as simple as plugging the cable in from the
> PK-900 to the 910...  I cannot receive and can only occasionally get a
> packet decoded on my D7A.
>
> I adjusted the level out of the PK-900 as the 910 wasn't wanting to
> transmit or was right on the edge and chopped, and this helped some, but
> I'm still only getting 1 out of every 3-5 packets decoded on the D7A.
>
> Do I need to use the 6 pin mini-din packet jack on the back for 9600
> baud?  On the 821H it was the 8 pin DIN and that's the cable I saved and
> am trying to use on the 910, with little success.  The manual says when
> in 9600 baud mode the audio should be constant and not squelch cut, but
> through the accessory DIN it is cut, do I have something else set wrong
> or am I on the wrong connector?
>
> Thanks!
>
> Ryan Butler
> KB0JQO
> ----
> Sent via amsat-bb@amsat.org. Opinions expressed are those of the author.
> Not an AMSAT member? Join now to support the amateur satellite program!
> To unsubscribe, send "unsubscribe amsat-bb" to Majordomo@amsat.org
----
Sent via amsat-bb@amsat.org. Opinions expressed are those of the author.
Not an AMSAT member? Join now to support the amateur satellite program!
To unsubscribe, send "unsubscribe amsat-bb" to Majordomo@amsat.org



AMSAT Top AMSAT Home