[Date Prev][Date Next][Thread Prev][Thread Next] - [Date Index][Thread Index][Author Index]

Re: help with satpc32



If you click "Options", in the upper right of the window that opens you will 
see a drop-down box where you select Model, Baud Rate, or Address, and 
another right below it where you select the appropriate value for each. 
Click the arrow beside the "Model" box, select "Baud Rate", and set it to 
9600 in the drop-down box below it.  Then select "Address" in the upper box, 
and use the up/down buttons below the lower box to set the address to $60 
$60, then press the "Address OK" and "Store" buttons.  You will then have to 
restart the program for the change to take effect.

George, KA3HSW


----- Original Message ----- 
From: "nick pugh" <quadpugh@bellsouth.net>
To: <amsat-bb@amsat.org>
Sent: Sunday, September 18, 2005 2:49 AM
Subject: [amsat-bb] help with satpc32


> The UL group is using satpc32 with a Icom 910H. Satpc32 can't control the
> radio. I have selected the 910h radio set the correct com port and the 
> speed
> of 9600 on the radio and the satpc32 program.  The radio address is set to
> 60H but I don't see where to set the radio address on satpc32.
>
>
> thanks in advance
> nick
----
Sent via amsat-bb@amsat.org. Opinions expressed are those of the author.
Not an AMSAT member? Join now to support the amateur satellite program!
To unsubscribe, send "unsubscribe amsat-bb" to Majordomo@amsat.org



AMSAT Top AMSAT Home