[Date Prev][Date Next][Thread Prev][Thread Next] - [Date Index][Thread Index][Author Index]

Re: satpc32/wisp



The easy way is RASCAL make a plug and play interface about $40 or put
transformers isolation to break up the ground loops and ferrites. I wimped
out and bough a store bought interface.

nick
----- Original Message ----- 
From: "Don Blachura" <haircutter@verizon.net>
To: <amsat-bb@amsat.org>
Sent: Thursday, September 15, 2005 4:03 PM
Subject: [amsat-bb] satpc32/wisp


> Hello Group,
> Run into a little problem here. I keep getting rf in the pc. Anyone on
else
> having that problem. I am using low power with my ft-847. Have rf torrids
on
> all the lines. But at least once during a pass the pc will freeze. Have to
> do a hard boot. Tried turning off all the gear and no luck. It has to be
the
> ft-847 or the dsp 2232. Can't see to isolate it.
> Any suggestions?.. The other problem is that I can't read the msgs in
> View-Dir". Left click on the messages but no luck. I must have a setting
> wrong in some program. Is it trying to read the message in Note pad. I
have
> Word as my reader.
>
> Don...w2xb
> ----
> Sent via amsat-bb@amsat.org. Opinions expressed are those of the author.
> Not an AMSAT member? Join now to support the amateur satellite program!
> To unsubscribe, send "unsubscribe amsat-bb" to Majordomo@amsat.org
>
>
> -- 
> No virus found in this incoming message.
> Checked by AVG Anti-Virus.
> Version: 7.0.322 / Virus Database: 267.10.21/96 - Release Date: 9/10/2005
----
Sent via amsat-bb@amsat.org. Opinions expressed are those of the author.
Not an AMSAT member? Join now to support the amateur satellite program!
To unsubscribe, send "unsubscribe amsat-bb" to Majordomo@amsat.org



AMSAT Top AMSAT Home