[Date Prev][Date Next][Thread Prev][Thread Next] - [Date Index][Thread Index][Author Index]

Re: Kenwood D700 and Doppler (PCSAT2)


I have had some success with the TS-2000 using the CAT function through the
RS-232 connector for Doppler control and running Soundcard AGWPE and a 
program (WinPack) on one other satellite to copy data.  Seemed to work 
fine. In
my present QTH my 70cm is inside and the copy is so poor I can not 
decode the
Packet data.

Might want to give AGWPE a try with any Terminal program.

Good luck,

Jerry  - K0HZI

Andrew Rich wrote:

>I have been receiving PACSAT2 data. I have noticed the 
>dramatic doppler shift of late. I have been moving the 
>VFO buy hand.
>Does anyone have a setup where the D700 is controlled by
>software to track for doppler ?
>If you use the internal TNC, you would have to drop out of 
>TNC mode, set the next freq and turn the TNC back on again.
>Bit messy, you may miss a packet while you are commandign the
>radio to the next freq.
>Ideas ?
Sent via amsat-bb@amsat.org. Opinions expressed are those of the author.
Not an AMSAT member? Join now to support the amateur satellite program!
To unsubscribe, send "unsubscribe amsat-bb" to Majordomo@amsat.org