[Date Prev][Date Next][Thread Prev][Thread Next] - [Date Index][Thread Index][Author Index]

Re: G-5500 rotor

If I remove either wire #1 or #2 on the AZ buss nothing happens. However if 
I remove wire #3 the needle jumps to the far RIGHT.

At 09:20 PM 4/22/2005, you wrote:
>One of the three wires that connects the feedback potentiometer in the
>rotator to the controller is broken or has come loose.  Check the 1, 2
>and 3 AZ terminals on back of the controller.
>Don Woodward
>On Fri, 2005-04-22 at 19:38 -0400, sco@sco-inc.com wrote:
> > I moved my G-5500 controller, wires attached, now i have a problem. Before
> > i moved it the AZ was reading 90 degrees and the antennas pointed EAST.
> > After moving it the controller now reads 0. Any ideas?
> >
> > W4SCO
Sent via amsat-bb@amsat.org. Opinions expressed are those of the author.
Not an AMSAT member? Join now to support the amateur satellite program!
To unsubscribe, send "unsubscribe amsat-bb" to Majordomo@amsat.org