[Date Prev][Date Next][Thread Prev][Thread Next] - [Date Index][Thread Index][Author Index]

Re: G-5500 rotor



Oops...  Missed where you said you moved it with the wires attached.

Check to make sure none pulled loose at the rotor.  Does the indicator move 
off zero if you turn the rotor?  If not, a loose or broken wire is almost 
certainly the culprit.  You're not getting any position feedback voltage 
from the rotor, so it'll stay on zero...

George, KA3HSW


----- Original Message ----- 
From: <sco@sco-inc.com>
To: <amsat-bb@amsat.org>
Sent: Friday, April 22, 2005 6:38 PM
Subject: [amsat-bb] G-5500 rotor


>I moved my G-5500 controller, wires attached, now i have a problem. Before 
>i moved it the AZ was reading 90 degrees and the antennas pointed EAST. 
>After moving it the controller now reads 0. Any ideas?
>
> W4SCO
----
Sent via amsat-bb@amsat.org. Opinions expressed are those of the author.
Not an AMSAT member? Join now to support the amateur satellite program!
To unsubscribe, send "unsubscribe amsat-bb" to Majordomo@amsat.org



AMSAT Top AMSAT Home