[Date Prev][Date Next][Thread Prev][Thread Next] - [Date Index][Thread Index][Author Index]

Re: LMR-400 Variants?



Bill,

All of the pins I have seen have had the same OD.  I can't say if you have
a complete connector for the larger diameter or not but as I pointed out,
you can certainly make a fit if you have a little shop equipment.

Good luck..Jim...W5VZF.

Dr. Jim Akers
Dept. of Electrical
and Computer Engineering
Miss. State Univ.


On Fri, 23 Jul 2004, Bill Acito W1PA wrote:

> Just a quick sanity check...  so, the pins all have the same O.D., but a
> different I.D. to accommodate the wire diameter, correct? So they all will
> fit in the N "body" without mods?
>
> And I should be able to go to RF Connection and just order the correct pins
> and swap them out (and use these on some 4XL that I have)?
>
> I also just noticed that the connectors I got recently came with sets of
> pins. Somewhere in there I should have a full connector for LMR-400. :-)
> http://users.erols.com/rfc/n.htm
>
>
> Bill
> W1PA
> ----- Original Message -----
> From: "Dr. Jim Akers" <jakers@ece.msstate.edu>
> >
> > Many years ago when I first started using the cable with the larger center
> > conductors, I did not know about the special center pin for the Type N
> > connectors.  I had a small drill press and a set of numbered bits and
> > just drilled out the hole so make it fit the conductor.  I don't remember
> > the number of the bit but if you have a set and a drill press, you can
> > find it experimentally in a few minutes.  Some of those pins are probably
> > still in use some where around the shack after all these years.
> ----
> Sent via amsat-bb@amsat.org. Opinions expressed are those of the author.
> Not an AMSAT member? Join now to support the amateur satellite program!
> To unsubscribe, send "unsubscribe amsat-bb" to Majordomo@amsat.org
----
Sent via amsat-bb@amsat.org. Opinions expressed are those of the author.
Not an AMSAT member? Join now to support the amateur satellite program!
To unsubscribe, send "unsubscribe amsat-bb" to Majordomo@amsat.org



AMSAT Top AMSAT Home