[Date Prev][Date Next][Thread Prev][Thread Next] - [Date Index][Thread Index][Author Index]

Re: Uni_trac 2000



Did you ...

1) Turn off rotator controller - set Zero on front with adjustment under
each meter

2) Turn on rotator controller and send needle to position to far right on
scale using right button(s) until it stops turning rotator (not just until
it reaches end of the scale) - then adjust pots AZ and EL "Full scale" on
back on the rotator to have meter read full scale on right of meter - do not
adjust the other two pots.

3) Now follow Uni_Trac instructions using _only_ the "out voltage adjust"
pots on the back of the controller.

73's

Don Woodward
KD4APP
AMSAT 33535
http://kd4app.webhop.org


----- Original Message ----- 
From: "Arnaldo De Sousa" <pak03107@pixie.co.za>
To: <amsat-bb@AMSAT.Org>
Cc: "Arnaldo De Sousa" <pak03107@pixie.co.za>
Sent: Saturday, June 19, 2004 13:15
Subject: [amsat-bb] Uni_trac 2000


I'm trying to setup a satellite station using Wisp and Uni_trac 2000. When
trying to calibrate the antenna it asks you to adjust the voltage controls
at the rear of the antenna controller box until the readings on the black
boxes read between 1022 and 1023. I can only get it to about 750. can anyone
please help in calibrating the antenna controller box with Uni_trac.

Many Thanks


Arnaldo
ZS5ADS
----
Sent via amsat-bb@amsat.org. Opinions expressed are those of the author.
Not an AMSAT member? Join now to support the amateur satellite program!
To unsubscribe, send "unsubscribe amsat-bb" to Majordomo@amsat.org


----
Sent via amsat-bb@amsat.org. Opinions expressed are those of the author.
Not an AMSAT member? Join now to support the amateur satellite program!
To unsubscribe, send "unsubscribe amsat-bb" to Majordomo@amsat.org



AMSAT Top AMSAT Home