[amsat-bb] ACRP version 1.10 and satellite problems

[John Geiger <johngeig@xxxxxxxxx>]

I recently installed version 1.10 of the ACRP-2000
radio control software, as it fixed a couple of bugs
in the satellite mode.  However, now I can't seem to
hear myself on the satellites.  Tried on FO29
yesterday and AO7 today.  Was hearing the beacons
fine, and hearing other stations coming in very
strongly, so the problem wasn't on receive.  The
output meter shows that I am putting out power, but
actually haven't hooked up a wattmeter yet.  I just
can't find my downlink signal.  Tune all over, but
can't find it.

I finally unistalled the 1.10 version and went back to
version 1.00, but had the same problem.  I guess I am
going to have to completely uninstall the program and
reinstall it again.  Kind of a pain since I will have
to go back and set up all parameters and memories
again.

Anyone else noticed a similar problem when upgrading
the software?

73s John NE0P
 

__________________________________
Do you Yahoo!?
Yahoo! SiteBuilder - Free web site building tool. Try it!
http://webhosting.yahoo.com/ps/sb/
----
Sent via amsat-bb@amsat.org. Opinions expressed are those of the author.
Not an AMSAT member? Join now to support the amateur satellite program!
To unsubscribe, send "unsubscribe amsat-bb" to Majordomo@amsat.org