Re: [amsat-bb] RE: Bias Tee

["Kyle Yoksh" <yokshs@xxxxxxxxxxxx>]

Hi Roger,

Here is a plan for a simple bias tee built into common CATV splitters..
These work well:

http://homepages.ihug.co.nz/~jpsl/powering_remote_units1.htm

73,

Kyle
K0KN
Amsat-NA member #35249

----- Original Message -----
From: "Roger" <rogermj01@direcway.com>
To: <amsat-bb@AMSAT.Org>
Sent: Friday, January 02, 2004 12:26 PM
Subject: [amsat-bb] RE: Bias Tee


> I know this has been discussed before but does anyone have a circuit
diagram
> for a bias-tee that I can use between my DEM 2400-144 downconverter and an
> Icom IC910H. Also is there enough current output from the Icom (which is
> usually used for the preamp) to drive the DEM downconverter which needs
400
> mA? This would allow me to skip the bias-tee altogether.
>
> Any help would be appreciated.
>
> Roger
>
> WB0GAI
>
>
>
> ----
> Sent via amsat-bb@amsat.org. Opinions expressed are those of the author.
> Not an AMSAT member? Join now to support the amateur satellite program!
> To unsubscribe, send "unsubscribe amsat-bb" to Majordomo@amsat.org
>

----
Sent via amsat-bb@amsat.org. Opinions expressed are those of the author.
Not an AMSAT member? Join now to support the amateur satellite program!
To unsubscribe, send "unsubscribe amsat-bb" to Majordomo@amsat.org