[Date Prev][Date Next][Thread Prev][Thread Next] - [Date Index][Thread Index][Author Index]

More G-5500B puzzlement

OK, I got the rotators all aligned but when doing the 'Full Scale'
adjustment for the elevation rotator (looking at the front of the control
box while adjusting the pot on the back) I accidentally adjusted the 'Out
Voltage Adj' pot. Nothing terrible happened - at least yet! But I'm not sure
it is anywhere near where it was when I started.

The manual says NOTHING about these pots (one each for el and az) and I
haven't been able to figure out exactly what they do from looking at the

SO, once again I appeal to the experts. Anybody know what these do and how
to adjust them? I would like to get this stuff set up correctly before it
goes on top of the (albeit short) tower.

Sent via amsat-bb@amsat.org. Opinions expressed are those of the author.
Not an AMSAT member? Join now to support the amateur satellite program!
To unsubscribe, send "unsubscribe amsat-bb" to Majordomo@amsat.org