[Date Prev][Date Next][Thread Prev][Thread Next] - [Date Index][Thread Index][Author Index]

Re: Connectors

At 00:35 2001-06-09 -0600, you wrote:
>I have been using RG213 and recently I acquired
>a roll of Belden 9913.  I found the center conductor
>does not quite fit into the N-connector contact
>(the same type I used for my RG-213).
>I am not quite keen to cut some of the center conductor
>i.e. remove a couple of wire strand but is that the way
>to go or should I be doing something else.
>I would be most grateful if someone could advise
>me on this.

Hi Dave

They sell a center pin that is bigger just for the 9.5 wire size of 9913.

73, Bill N4XEO

E- Mail mailto: n4xeo@amsat.org
home page: http://www.qsl.net/n4xeo
F.A.D.C.A.: http://www.fcrosby.com/fadca
FPAC: http://www.qsl.net/fpac
ICQ: 19219163

Via the amsat-bb mailing list at AMSAT.ORG courtesy of AMSAT-NA.
To unsubscribe, send "unsubscribe amsat-bb" to Majordomo@amsat.org