[Date Prev][Date Next][Thread Prev][Thread Next] - [Date Index][Thread Index][Author Index]

Re: Connectors




I've always just taken an Xacto knife and shaved off enough of the center
conductor to get it to fit.  As far as I can tell, this doesn't change the
impedance enough to be measurable.

> N connectors for 9913 require a larger center pin. You can find N
> connectors made especially for 9913 at various places.
>
> At 12:35 AM 6/9/01 -0600, you wrote:
> >Hi,
> >
> >I have been using RG213 and recently I acquired
> >a roll of Belden 9913.  I found the center conductor
> >does not quite fit into the N-connector contact
> >(the same type I used for my RG-213).
> >I am not quite keen to cut some of the center conductor
> >i.e. remove a couple of wire strand but is that the way
> >to go or should I be doing something else.
> >
> >I would be most grateful if someone could advise
> >me on this.
> >
> >73,
> >Dave
> >
> >
> >____________________________________________________________________
> >Get free email and a permanent address at http://www.netaddress.com/?N=1
> >
> >----
> >Via the amsat-bb mailing list at AMSAT.ORG courtesy of AMSAT-NA.
> >To unsubscribe, send "unsubscribe amsat-bb" to Majordomo@amsat.org
>
> ----
> Via the amsat-bb mailing list at AMSAT.ORG courtesy of AMSAT-NA.
> To unsubscribe, send "unsubscribe amsat-bb" to Majordomo@amsat.org
>

----
Via the amsat-bb mailing list at AMSAT.ORG courtesy of AMSAT-NA.
To unsubscribe, send "unsubscribe amsat-bb" to Majordomo@amsat.org



AMSAT Top AMSAT Home