[Date Prev][Date Next][Thread Prev][Thread Next] - [Date Index][Thread Index][Author Index]

Re: Connectors



N connectors for 9913 require a larger center pin. You can find N 
connectors made especially for 9913 at various places.

At 12:35 AM 6/9/01 -0600, you wrote:
>Hi,
>
>I have been using RG213 and recently I acquired
>a roll of Belden 9913.  I found the center conductor
>does not quite fit into the N-connector contact
>(the same type I used for my RG-213).
>I am not quite keen to cut some of the center conductor
>i.e. remove a couple of wire strand but is that the way
>to go or should I be doing something else.
>
>I would be most grateful if someone could advise
>me on this.
>
>73,
>Dave
>
>
>____________________________________________________________________
>Get free email and a permanent address at http://www.netaddress.com/?N=1
>
>----
>Via the amsat-bb mailing list at AMSAT.ORG courtesy of AMSAT-NA.
>To unsubscribe, send "unsubscribe amsat-bb" to Majordomo@amsat.org

----
Via the amsat-bb mailing list at AMSAT.ORG courtesy of AMSAT-NA.
To unsubscribe, send "unsubscribe amsat-bb" to Majordomo@amsat.org



AMSAT Top AMSAT Home