[Date Prev][Date Next][Thread Prev][Thread Next] - [Date Index][Thread Index][Author Index]

Re: 3373 & filter?



I had to make my own little boards. I used an MMIC teflon PWB that down east
microwave sells. I was able to make both boards out of a single mmic board.
If you remove the metal covers, you will find a copper stamped filter
suspended in the air. Don't take it appart until you have the board
material. You will also need some copper tape to ground it all around it
since the board is a little recessed and it is hard to bolt down.

Pieter

----- Original Message -----
From: "Kevin Uhlir" <kevinu@flochart.com>
To: <amsat-bb@amsat.org>
Cc: <rfspace@yahoo.com>
Sent: Thursday, May 10, 2001 12:01 PM
Subject: 3373 & filter?


> I'm thinking about puting that 2450 +/- 50 filter into my 3373.
>
> I've looked at Pieter's photos of the mod.
>
> Pieter, did you have to make a pc board/stripline to install the
> filter, or does the photo show whats under the two metal blocks
> over the stock filters?  I only have 1 (one) 3373, it represents my
> only downlink capability, so I dont want to pull the metal blocks
> off unless i know its ok.
>
> Kevin

----
Via the amsat-bb mailing list at AMSAT.ORG courtesy of AMSAT-NA.
To unsubscribe, send "unsubscribe amsat-bb" to Majordomo@amsat.org



AMSAT Top AMSAT Home