[Date Prev][Date Next][Thread Prev][Thread Next] - [Date Index][Thread Index][Author Index]

RE: L Band Uplink Experience - AO40

Hello Mark & John,

I also have one of these 20turn helix for 23cm. It has been outside on my
roof for over 2 years.
I live in the mountians and the last winter was cold & wet !!

The ant has good swr and good quality.

all the best from DL land..rgs lawrence (dl1flw ex da1la ex 9h3wr)

-----Original Message-----
From: owner-AMSAT-BB@AMSAT.Org [mailto:owner-AMSAT-BB@AMSAT.Org]On
Behalf Of Mark L. Hammond
Sent: Wednesday, May 09, 2001 10:06 PM
To: Santillo, John (John); amsat-bb@AMSAT.Org
Subject: RE: [amsat-bb] L Band Uplink Experience - AO40

Hi John,

I would say it is "good" to "very good."  About the only thing that keeps
it from being "excellent" is the fact the wire in the helix is soft
aluminum, and its cost :)  It wasn't cheap--I bought both a 30 turn 2.4 GHz
helix and 20 turn 1.2 GHz helix at the same time.  It was about $300 US
total for the pair by the time I paid for shipping, etc.  I did have to
reshape the end of the helix a bit, as it had been squished a bit during

I would call the matching part perhaps a little fragile?  The aluminum wire
is flattened, and a hole is drilled through it so a small bolt passes
through and is attached with a washer/nut.

While I can't truly measure the SWR, I have pretty good faith in the "power
out" indication on my TS-790A.  If it's reading about 80-100% of full
scale, it's a good match (as measured/tested on 2M and 70cm).  The match
appears to be good, and it appears to work pretty well as I worked a couple
of stations today with what has to be less than 5 watts at the antenna.

I expect at least several years of good service from it, so overall I'm
happy with it.  If I were to do it again, I might have built one and saved
some good money.  However, I didn't like the idea of burning up my $600
1.2GHz module with a poorly matched antenna ;-)

As for the 30 turn helix--it's in the closet since the 2'x3' BBQ style dish
I bought with my TranSystem converter clearly+ out performs the helix.  I'm
thinking it might be fun as the receiver side of a portable setup.


Mark N8MH

At 03:52 PM 5/9/2001 -0400, you wrote:
>Hi Mark, I was wondering what your thoughts were on the
>Wimo helix antenna.  I'm thinking about purchasing one
>but you're the first I heard that actually put one to the
>test.  How's the quality and construction, etc. ?
>TNX & '73,
>         ----------
>         From:  Mark L. Hammond [SMTP:hammond@surrealnet.net]
>         Sent:  Wednesday, May 09, 2001 6:19 AM
>         To:  DA1LA@t-online.de; amsat-bb@AMSAT.Org
>         Subject:  Re: [amsat-bb] L Band Uplink Experience - AO40
>         Currently, I can uplink on mode U with a homebrew 9 turn helix and
>35 watts
>         (out of the rig) and on mode L with a 20 turn Wimo helix and 10
>watts (out
>         of the rig).  My feedline is about 70' of 9913FX(flexi), so I'm
>guessing I
>         have about 5 watts or less actually reaching the antenna.  Not
>         rig is a Kenwood TS-790A with the 1.2 GHz module (10 watts out).
>         I could hear myself pretty well on mode U, and out of curiosity, I
>         mode L uplink for the first time ever.  Surprise!  I could hear a
>         carrier.  It was tough hearing myself on SSB, but I did hear
>         enough that I hoped somebody with a hot receiver could answer my
>calls.  I
>         got a few people's attention, but nobody replied.  L mode CW would
>         been quite doable, but SSB was marginal indeed.
>         I did successfully work DF4PV as my first AO-40 QSO this AM on
>         U/S!  Thanks!!! :-)
>         BTW I heard you this pass Larry, but couldn't get a reply :)
>         73,
>         Mark N8MH

Mark L. Hammond  [N8MH]

Via the amsat-bb mailing list at AMSAT.ORG courtesy of AMSAT-NA.
To unsubscribe, send "unsubscribe amsat-bb" to Majordomo@amsat.org

Via the amsat-bb mailing list at AMSAT.ORG courtesy of AMSAT-NA.
To unsubscribe, send "unsubscribe amsat-bb" to Majordomo@amsat.org