Re: [amsat-bb] DEM 1296 for satellite work, and need a "vanilla" 9600 FSK

["John / NS1Z" <ns1z@xxxxxxxx>]

I asked the folks at DEM about this and was advised that the board would not
modify that "far" away from the design frequency.

----- Original Message -----
From: Christopher M. Best <bestc@email.uah.edu>
To: Amsat-Bb <amsat-bb@AMSAT.Org>
Sent: Wednesday, April 25, 2001 8:55 PM
Subject: [amsat-bb] DEM 1296 for satellite work, and need a "vanilla" 9600
FSK


> Is it possible to convert one of the newer Down East Microwave 1296 to 144
> transverters to work on 1266MHz for amateur satellite work? And is there
any
> way I can modify a G3RUH 9600 baud TNC to not do bit swapping on the data
it
> is sending?  I am transmitting some data that I do not want the TNC to
> encapsulate.
>
> Christopher Best
>                                           KB3DXR
> ----
> Via the amsat-bb mailing list at AMSAT.ORG courtesy of AMSAT-NA.
> To unsubscribe, send "unsubscribe amsat-bb" to Majordomo@amsat.org
>

----
Via the amsat-bb mailing list at AMSAT.ORG courtesy of AMSAT-NA.
To unsubscribe, send "unsubscribe amsat-bb" to Majordomo@amsat.org