[Date Prev][Date Next][Thread Prev][Thread Next] - [Date Index][Thread Index][Author Index]

AIDC 3733 Picture of the Stub



Mark,

I posted a message on the BB on 4/3, here is an excerpt:


2. Notch in response at 2400  -- there is a 5-8 dB notch in response at 2400 
MHZ or so on some of the converters.   The little piece of rigid coax that is 
on the output of the preamp section (before it goes to the second comb 
filter) appears to be the culprit. It connects near the rear comb filter and 
runs up above the circuit board to near the front comb filter. It appears to 
be a 2.4 GHZ stub. I cut one at the connection to the preamp output, and the 
gain is now flat across the range.  

THE CUT IS MADE ON THE CENTER CONDUCTOR OF THAT COAX.

I have a picture of this part of the downconverter on an Ebay auction.  To 
view it, go to ebay.com, search for auction number 1227956478.  It is the 
upper right picture, click on it to make it larger.  The left side of the 
stub (shorted end) can be seen sticking up at the bottom by the open front 
end filter (left part of the picture) and the connection that needs to be cut 
is connected near the little green thing on the output side (right part of 
the picture) of the preamp where it connects into the second filter. 

I hope the picture and description helps.  

Bob Seydler
K5GNA
k5gna@aol.com
----
Via the amsat-bb mailing list at AMSAT.ORG courtesy of AMSAT-NA.
To unsubscribe, send "unsubscribe amsat-bb" to Majordomo@amsat.org



AMSAT Top AMSAT Home