[Date Prev][Date Next][Thread Prev][Thread Next] - [Date Index][Thread Index][Author Index]

Re: Surface mount component holder



-----BEGIN PGP SIGNED MESSAGE-----

On Sat, 27 Jan 2001 09:34:43 -0800, John Mock wrote:

>I hope nearly everyone here would assume that said solder is held in a
>plastic tube, and the plastic tube goes between the teeth.  The problem is
>these days it's hard to find such dispensers without paint on the outside
>in the 'States.  That's why i haven't used that trick on years.

Get a clear plastic Fuji 35mm film canister and make a small hole in
the top.  Roll up a length of solder and place it in the film can. 
Handy for the toolbox, and fits in all but the smallest mouths.

- -- 
Jim Shorney      -->.<--Put complaints in this box
jshorney@inebraska.com
nu0c@amsat.org
Ham Radio NU0C
Lincoln, NE, USA
EN10KA
http://incolor.inetnebr.com/jshorney/
-----BEGIN PGP SIGNATURE-----
Version: 2.6.2

iQCVAwUBOnOnZUCBN4ScxcExAQHLUQQAmt1zp+kN5gs9QXQV8MPI+yzHnpWdC4QU
faVcJPnQJ8NdhFd4sLaKXJWyEwPZ6mzpDPNr4Ub4aQj98oJk/SSggS34V6ijZNwo
IrG1/2kF+Jii7e0ym6rQSYLEn2ljt043fTwOm77LTImT0sy0DcjR0CYzLY7g4AS/
Gm0/AVBUhcI=
=cicF
-----END PGP SIGNATURE-----


----
Via the amsat-bb mailing list at AMSAT.ORG courtesy of AMSAT-NA.
To unsubscribe, send "unsubscribe amsat-bb" to Majordomo@amsat.org



AMSAT Top AMSAT Home