Re: [amsat-bb] FT-726R question

["ATVQ" <atvq@xxxxxxxxxxx>]

Just one frequency at a time is displayed. In duplex mode, it stays on the
receive frequency - out of duplex mode it will switch and show the transmit
frequency when transmitting, receive frequency when receiving. In duplex
mode you can flip one switch and view/change either the transmit or receive
frequency. Takes a little getting used to, but not bad. I forget sometimes
which frequency I am on and tune the wrong one. But the more I do it, the
less mistakes I make!

Gene Harlan - WB9MMM
Harlan Technologies - publisher of
OSCAR Satellite Report - OSR@hampubs.com
Amateur Television Quarterly - ATVQ@hampubs.com
http://www.hampubs.com


----- Original Message -----
From: "tom P." <tporcella@yahoo.com>
To: <amsat-bb@AMSAT.Org>
Sent: Tuesday, September 05, 2000 12:31 PM
Subject: [amsat-bb] FT-726R question


> Hello.
>
> I'm considering picking up an old Yaesu 726-R.  After
> reading through the qst review, I couldn't tell if the
> rig displays both uplink and downlink freq's at the
> same time?  Also, since the vfo's can't be yoked
> together, I would imagine that getting uplink/downlink
> freqs lined up would be a bit laborious.  Any comments
> from owners would be appreciated.
>
> Tnx es 73
>
> Tom
> NK6T
>
>
> __________________________________________________
> Do You Yahoo!?
> Yahoo! Mail - Free email you can access from anywhere!
> http://mail.yahoo.com/
> ----
> Via the amsat-bb mailing list at AMSAT.ORG courtesy of AMSAT-NA.
> To unsubscribe, send "unsubscribe amsat-bb" to Majordomo@amsat.org
>

----
Via the amsat-bb mailing list at AMSAT.ORG courtesy of AMSAT-NA.
To unsubscribe, send "unsubscribe amsat-bb" to Majordomo@amsat.org