[Date Prev][Date Next][Thread Prev][Thread Next] - [Date Index][Thread Index][Author Index]

Re: WiSP Rotor Configuration



When you say re-installing WiSP, do you mean you used the INSTALL program. 
What do you mean "the azimuth and elevation just don't show in the
software?"  Tell me step by step what you did to reinstall it.

"Joel B. Black" wrote:
> 
> Was having some problems with my PC, so I decided to re-format over the
> weekend.  I just got around to re-installing wisp on my PC and I cannot
> configure my rotor - the azimuth and elevation just don't show in the
> software; therefore, I cannot calibrate it.
> 
> I have version 2.03 of GSC.  I am doing nothing different (as far as I can
> tell) for the calibration.  I have tried shutting down, turning off, and
> restarting the PC.  I have tried starting WiSP with the rotor controller on
> and then starting with the rotor controller off, then turning it on.
> 
> I'm using the KCT and I *do* have the type as Level 1.  My KCT *does* work
> with NOVA, so I'm pretty sure it's not the KCT board.  The hex address is
> correct and all worked before the re-format.
> 
> Any suggestions?
> 
> Tnx es 73,
> 
> Joel B. Black, K2SAT
> AMSAT..........32589
> AMSAT Local Area Coordinator
> k2sat@amsat.org
> http://www.mindspring.com/~jbblack
> AO-10, AO-27, FO-20, FO-29, SO-35, UO-14
> KO-25, TO-31, UO-22, UO-36
> 
> ----
> Via the amsat-bb mailing list at AMSAT.ORG courtesy of AMSAT-NA.
> To unsubscribe, send "unsubscribe amsat-bb" to Majordomo@amsat.org

-- 
73, Roy

Internet: w0sl@amsat.org
Home Page: http://home.swbell.net/rdwelch
----
Via the amsat-bb mailing list at AMSAT.ORG courtesy of AMSAT-NA.
To unsubscribe, send "unsubscribe amsat-bb" to Majordomo@amsat.org



AMSAT Top AMSAT Home